Rollable Solar Panels
Use a damp cloth with a mild soap solution and allow to dry thoroughly.
Always roll the Rollable Solar Panel solar side out. Rolling solar side in will damage the panel and affect performance.
Rolling the panel too tightly will likely reduce the effectiveness of the solar panel. The inner roll should measure at least 3” across (42 Watt Rollable (R-42) and 60 Watt Rollable (R-60) at least 5”).
Rollable Solar Panels power portable electronic devices ranging from cell phones to laptops and more. Rollable Solar Panels are also perfect for keeping 12V batteries topped off and ready to go when you are. Connect up one of our weatherproof panels and start your boat, car, RV or ATV the first time.
Place your Rollable Solar Panel perpendicular to the sun for best performance.
Yes, Rollable Solar Panels are designed for permanent outdoor installation and are 100% waterproof with an IP67 rating.
Yes, Foldable and Rollables can be daisy-chained in parallel using a Daisy Chain Cable (RA-6-HD) (Be sure to check the voltages of either panel. Standard Foldable and Rollables are 15.4V but 30V versions for specific products are available as well).
Yes, Rollable Solar Panels come with a one-year limited warranty. Learn more.
Rollable Solar Panels are designed to charge 12V flooded, gel, and AGM lead-acid batteries. With the proper accessory, Rollable Solar Panels can charge any number of different available batteries such as the EcoFlow DELTA or Inergy Flex Mobile Power Stations. Confirm functionality with the battery manufacturer.
To store the product, simply disconnect the cords. Ensure the product is clean and dry (use a damp cloth and a mild soap solution), and then roll with the solar side facing out. Use the attached Velcro® strip to hold in place when rolled. Store in a cool dry environment (temperature range -30-60° C).
Rollable Solar Panels are incredibly durable, flexible and 100% waterproof. General flexing provides no issues at all. Do not fold the solar panel material as this will cause shunts and affect overall performance.
A charge controller is not required if the battery capacity is 100x greater (or more) than the panel output. For example, a 100Ah battery would not need a charge controller as long as the panel output is 1A or less. If a charge controller is required, please size it appropriately to the panel output.
You can use the grommets on each of the corners and a tie cord to hold the panel in place. This is important to reduce loss or damage from high winds.
You may leave the panel permanently connected to your battery since the built-in blocking diode in the junction box blocks the draining of your battery. As with any permanent connection to a battery, safely clean the connection as needed (charge controller may be necessary).
Amorphous silicon on a flexible polyimide substrate.
10,000 lux (equivalent to a cloudy day).
Our standard connector type is Aptiv Weather Pack (formerly Delphi). Additional connector options are available however order quantity restrictions may apply.