Rollable Solar Panels
Use a damp cloth with a mild soap solution and allow to dry thoroughly.
Always roll the Rollable Solar Panel solar side out. Rolling solar side in will damage the panel and affect performance.
The inside dimension of the roll should be a minimum of 3” across.
Rollable Solar Panels power portable electronic devices ranging from cell phones to laptops and more. Rollable Solar Panels are also perfect for keeping 12V batteries topped off and ready to go when you are. Connect up one of our weatherproof panels and start your boat, car, RV or ATV the first time.
Place your Rollable Solar Panel perpendicular to the sun for best performance.
Yes, Rollable Solar Panels are designed for permanent outdoor installation and are 100% waterproof with an IP67 rating.
Yes, Foldable and Rollables can be daisy-chained in parallel using a Daisy Chain Cable (RA-6-HD) (Be sure to check the voltages of either panel. Standard Foldable and Rollables are 15.4V but 30V versions for specific products are available as well).
Yes, Rollable Solar Panels come with a one-year limited warranty. Learn more.
Rollable Solar Panels are designed to charge 12V flooded, gel and AGM lead-acid batteries.
With the proper accessory, foldables can charge any number of different available batteries such as the RIVER Mobile Power Station. Confirm functionality with the battery manufacturer.
To store the product, simply disconnect the cords. Ensure the product is clean and dry (use a damp cloth and a mild soap solution), and then roll with the solar side facing out. Use the attached Velcro® strip to hold in place when rolled.
Rollable Solar Panels are incredibly durable, flexible and 100% waterproof. General flexing provides no issues at all. Do not fold the solar panel material as this will cause shunts and affect overall performance.
If your battery capacity (Ah) divided by 100 is less than or equal to the panel current (assuming that the voltages are matched) you do not need to use a charge controller in your setup. If however, the battery capacity divided by 100 is greater than the panel current. Make sure to use a charge controller to ensure safe charging.
You can use the grommets on each of the corners and a tie cord to hold the panel in place. This is important to reduce loss or damage from high winds.
You may leave the panel permanently connected to your battery since the built-in blocking diode in the junction box blocks the draining of your battery. As with any permanent connection to a battery, safely clean the connection as needed (charge controller may be necessary).
Amorphous silicon on a flexible polyimide substrate.
Our standard connector type is Delphi Weather Pack. Additional connector options are available however order quantity restrictions may apply.